Part Modeling > Engineering Features > Round > Piece Management > To Exclude Round Pieces
To Exclude Round Pieces
To exclude round pieces, the current round set must contain two or more round pieces that use one explicit placement reference. This can occur if the round geometry breaks due to non-tangent chains. It can also occur if a single round piece cannot be created at a certain radius value, for example, a round that is too large to sweep around a corner.
1. Select the references for the round and click Model > Round. The Round tab opens, and preview geometry of the round appears.
2. Click the Pieces tab.
3. On the Sets list, select the round set that contains the piece that you want to exclude. All of the round pieces for the current round set are listed in the Pieces table.
4. In the Pieces table, select the round piece that you want to exclude and select Excluded. The round piece is excluded from the model.
5. If you want to exclude another round piece, repeat step 3 and step 4.
6. To include an excluded round piece, select the piece and select Included in the Pieces table.
7. Close the Pieces tab to activate Sets mode and continue to work with rounds.
8. Click .
You can also use Excluded or Included on the Pieces tab shortcut menu.
If you excluded multiple pieces in the current round set and want to quickly include them all, select All included on the Pieces tab shortcut menu.
To quickly locate a piece on your model, place your cursor over each piece in the Pieces table, and the piece is dynamically highlighted in the graphics window.