Work with Procedures in Vuforia Editor > Step Check™ > Enable and Train Step Check > Start Training and Test the Results
  
Start Training and Test the Results
1. Navigate to the STEP CHECK tab.
2. Click START TRAINING.
* 
On average, it may take about 10 minutes to train a single step. However, this can vary based on the number of sample images.
3. Once training is complete, publish the procedure again.
4. After publish is complete, view the procedure in Vuforia Vantage to test the training results and ensure that they are accurate and acceptable. If needed, you can collect more training images, update the training results, and republish the procedure.
5. Next, you’ll finalize Step Check and republish your procedure.