Creo Tutorials > Creo Flow Analysis Tutorials > Beginners Tutorials > Creo Flow Analysis Beginners Tutorials > Tutorial 3 - Cyclone Separator > Cyclone Separator Overview
  
Cyclone Separator Overview
Cyclone separators are used to remove particles from an air stream. Air enters the inlet at a velocity of 5 m/s and exits at an outlet pressure of 101325 Pa. You can see the geometry and conditions for the simulation in the figure below:
1. Inlet – Velocity = 5 m/s
2. Outlet – Specified Pressure Outlet = 101325 Pa
Air density = 1.1614 kg/m3
Water viscosity = 1.846 e-05 Pa.s
The exercises in the Flow Analysis simulation are:
1. Cyclone Separator Exercise 1—Extracting the Fluid Domain
2. Cyclone Separator Exercise 2—Preparing the Mesh
3. Cyclone Separator Exercise 3—Defining Physics Modules
4. Cyclone Separator Exercise 4—Assigning Boundary Conditions
5. Cyclone Separator Exercise 5—Creating Monitoring Points
6. Cyclone Separator Exercise 6—Performing the Simulation
7. Cyclone Separator Exercise 7—Analyzing Results