Creo Tutorials > Creo Flow Analysis Tutorials > Beginners Tutorials > Creo Flow Analysis Beginners Tutorials > Tutorial 3 - Cyclone Separator > Cyclone Separator Exercise 7—Analyzing Results
  
Cyclone Separator Exercise 7—Analyzing Results
This exercise describes how you analyze the results during and after the simulation. To hide CAD surfaces (not the fluid domain), switch between CAD Bodies and Flow Analysis Bodies. Click XYPlot Panel to view the XY Plot.
Viewing the Pressure Contours on a Boundary
Pressure: [Pa] : Flow
101350
101320
1. In Boundary Conditions, under General Boundaries select CYCLONE_4_1_FLUID.
2. In the Properties panel, View tab, under Surface, select the following values for the options listed:
Keep drawingYes
GridNo
OutlineNo
VariablePressure: [Pa] : Flow
Min—101320
Max—101350
Viewing the Streamlines in the Domain
Velocity Magnitude: [m/s] : Flow
5.95
0
1. Add Streamline01 to the Flow Analysis Tree and select it.
2. In the Properties panel, Model tab, select the following values for the options listed:
Line Thickness—0.007
Animation Time Size—0.0001
3. In the Properties panel, View tab, under Surface, select the following values for the options listed:
VariableVelocity Magnitude: [m/s] : Flow
Min—0.0
Max—5.95
4. In the Flow Analysis Tree, under General Boundaries select BC_2.
5. In the Properties Panel, Model tab, for Streamline, set Release Particle to Yes.
Viewing an Isosurface of Points with Velocity Below 1 m/s
Velocity Magnitude: [m/s] : Flow
1.0
0.00000
1. Click Flow Analysis > Isosurface. A new entity Isosurface 01 appears under Derived Surfaces in the Flow Analysis Tree.
2. Select Isosurface 01.
3. In the Properties panel, Model tab, set values for the options as listed below:
Isosurface VariableVelocity Magnitude: [m/s] : Flow
TypeBelow Value
Value—1.0
4. In the Properties panel, View tab, for Surface set values for the options as listed below:
VariableVelocity Magnitude: [m/s] : Flow
Min—0.0
Max—1.0
Plotting the Mass Flux at the Outlet Boundary
1. In the Flow Analysis Tree, under Results click Boundaries.
2. Select BC_2.
3. Click XYPlot. A new entity xyplot1 is added in the Flow Analysis Tree under Results > Derived Surfaces > XY Plots.
4. Select xyplot1.
5. In the Properties panel, View tab, set VariableMass Flux.
6. Click Stop and Run, if required.
Plotting the Pressure at Monitoring Point
1. In the Flow Analysis Tree, under Results click Monitoring Points.
2. Select Point01.
3. Click XYPlot. A new entity xyplot2 is added in the Flow Analysis Tree under Results > Derived Surfaces > XY Plots.
4. Select xyplot2.
5. In the Properties Panel, View tab, set VariablePressure.
6. Click Stop and Run, if required.