Column
|
Description
|
---|---|
Spares Pool
|
The name assigned to the spares pool in the RBD Spares file. This parameter is display-only.
|
Data Type
|
The type of spares data that can be optimized for the spares pool. This parameter is display-only. Because quantities for onsite spares, offsite spares, and replenishment levels can be optimized, this parameter lists three choices for each spares pool: Onsite Quantity, Offsite Quantity, and Replenishment Level.
|
Optimize
|
Indicates whether to compute the optimal quantity when RBD calculations next run.
• When this checkbox is cleared (default), an optimal quantity is not calculated. In this case, Minimum and Maximum are unavailable, and Use Optimized Result is available only if a valid value already appears for Optimized Result from a previous optimization calculation.
• When this checkbox is selected, an optimal quantity is calculated based on the values specified for Minimum and Maximum, which are made available. In this case, Use Optimized Result is selected but unavailable.
|
Minimum
|
The minimum value that should be considered for the quantity during optimization. The default is 0. This parameter cannot be blank. The value that you enter must be 0 or greater, and it must be less than the value that you enter for the maximum.
|
Maximum
|
The maximum value that should be considered for the quantity during optimization. The default is #, which means infinite or no upper bound. The value that you enter must be greater than or equal to the value that you enter for the minimum.
|
Optimized Result
|
Displays the result from the last optimization calculation that was performed. This value is display-only. If NA (for Not Applicable) is shown, the optimal quantity has not yet been calculated.
|
Use Optimized Result
|
Indicates whether or not to use the optimal quantity calculated for the spares pool when RBD calculations are next run. This checkbox is available when Optimize is cleared and the value for Optimized Result is either not NA or is greater than 0. In this case, you can select this checkbox to use the existing optimal quantity value. This checkbox is selected and unavailable if Optimize is selected. In this case, an optimal quantity is calculated based on the specified parameter values and this value is then used.
|