ResetAllParams configuration parameter (TDK)
Syntax (prefix with dash in a Generation Settings Scheme):
ResetAllParams
The ResetAllParams configuration parameter unsets all Configuration Parameters that have been set to that point. After the ResetAllParams configuration parameter, you can specify Configuration Parameters to set.
This is useful if you want to unset global settings that are specified in a referenced Configuration Parameter File, in particular when the Configuration Parameter does not have a value that can be reset, such as Log_Time.
 |
• After a ResetAllParams configuration parameter, use the PerUser=1 configuration parameter (unless you are specifically using TDK with PerUser set to 0). If you do not use the PerUser=1 configuration parameter, TDK will not be able to open a model it was previously working with. You should review which Configuration Parameters you are resetting, because you may want to reset some of them after the ResetAllParams configuration parameter.
• Do not use the ResetAllParams configuration parameter in the registry.
ResetAllParams
PerUser=1
|