建立截面圓頂(基本)
1. 將 allow_anatomic_features 組態選項設定為 yes,以使「全部指令」(All Commands) 清單中的「截面圓頂」(Section Dome) 指令可供使用。
2. 將「截面圓頂」(Section Dome) 指令新增至功能區上所需的使用者定義群組。
3. 按一下「截面圓頂」(Section Dome)。出現「選項」(OPTIONS) 選單。
4. 指定圓頂的類型:
◦ 「掃描」(Sweep) - 沿著第二個輪廓掃描第一個輪廓,同時沿著第一個輪廓掃描第二個輪廓來建立圓頂,然後用兩個曲面的算術平均來建立圓頂。
◦ 「混成」(Blend) - 透過混成兩個或更多截面建立圓頂。
◦ 「無輪廓」(No Profile) - 不用輪廓建立混成圓頂。已選取「掃描」(Sweep) 選項時,該選項不可用。
◦ 「一個輪廓」(One Profile) - 用一個參照輪廓建立圓頂特徵。