Creo Simulate must be installed on your computer in order to use Topology Optimization.

Creo Topology Optimization helps you find the best distribution of material in your 3D model to meet your goals, such as to reduce mass, avoid a resonance mode, or minimize thermal stress or deformation. Topology optimization does not require an initial design. Typically, the design starts with a block of material formed by a large number of finite elements, either in a part or in a single component of an assembly.

The topology optimization eliminates the unnecessary elements from the block.

During this process, you set up and run optimization studies. Then, you can use the results to generate an optimized structure that removes unnecessary material from a defined design space. The output of the topology optimization process is a reconstructed optimized model, either a b-rep (boundary representation) or tessellated (faceted) model.

Creo Topology Optimization is the result of collaboration between PTC and Vanderplaats Research & Development, Inc. (VR&D). It combines the expertise at PTC in bridging the physical and digital worlds, with the expertise at VR&D in optimization. Your experience is seamless as you move between Creo and GENESIS Structural Analysis and Optimization Software from VR&D.