[Contents]

[Index]

[Books]

CoCreate OneSpace Designer - Commands Reference Manual

SDPCB_CYLINDER_MODEL terminate action

Creates a cylinder part (e.g. a resistor).

Syntax


   (SDPCB_CYLINDER_MODEL)
        (:PARTNAME)       | part name |
        (:PIN_1)          | 2D position |
        (:PIN_2)          | 2D position |
        (:PARTTYP)        | part type |
        (:BODY_DIAM)      | positive length |
        (:BODY_LENGTH)    | positive length |
        (:LEAD_DIAM)      | positive length |
        [(:MOUNT_CLEAR)   | positive length | ]

Options

:PARTNAME - specifies a part name.
:PIN_1 - specifies a 2D position.
:PIN_2 - specifies a 2D position.
:PARTTYP - specifies a part type (e.g. "resistor", "capacitor", "dip").
:BODY_DIAM - specifies the diameter of the cylinder.
:BODY_LENGTH - specifies the length of the cylinder.
:LEAD_DIAM - specifies the lead diameter.
:MOUNT_CLEAR - specifies the mounting clearance of the part.

See also

SDPCB_ADD_PART terminate action SDPCB_ADD_PROFILE terminate action SDPCB_BLOCK_MODEL terminate action SDPCB_CAN_MODEL terminate action SDPCB_CHECK_PROFILE terminate action SDPCB_CREATE_PCA terminate action SDPCB_DIP_MODEL terminate action SDPCB_EDIT_MODEL terminate action SDPCB_EXPAND_MODEL terminate action SDPCB_EXTRUDE_MODEL terminate action SDPCB_GENERIC_MODEL terminate action SDPCB_LOAD_MODEL terminate action SDPCB-SAVE-MODEL terminate action SDPCB_SOT_MODEL terminate action SDPCB_SUBSTITUTE_MODEL terminate action (IDF only)

[Contents]

[Index]

[Books]