To Modify a Capping Surface
Use this procedure to modify a solid cut through your model.
1. Click
View >
Edit. The
Results Surface Definition dialog box opens.
2. To redefine the surface definition, select a method from the
Define By drop-down list.
3. If you changed your surface definition method to
Three Points, use the selector arrow to
select three points.
4. If you changed your surface definition method to UCS, use the selector arrow to select the desired coordinate system.
6. If you want to redefine which side of the capping surface
Creo Simulate trims, select
Above or Below, as appropriate.
7. If you want to change the cutting surface depth, use one of the following methods:
◦ Manually change the depth by entering a new value in the
Depth field.
◦ Dynamically change the depth by clicking
Dynamic and dragging the mouse to increase or decrease the depth. Click the middle mouse button when you are finished repositioning the cutting surface.
Creo Simulate updates the Depth value on the Results Surface Definition dialog box to reflect your change.
8. Click OK to close the dialog box.