Creo Expert Moldbase Extension > Ejector Pins > About Ejector Pins
  
About Ejector Pins
Use an ejector pin to push the cold plastic part out of the cavity insert when the mold base is opened. Click EMX Components > Ejector Pin and click one of the following commands:
Ejector Pin Designer—Define Ejector Pins dynamically
Ejector Pin—Defines a new ejector pin.
Identify ejector pin owner models —Prepares the selected parts for predefining ejectors with layout curve
Delete all Ejector Pins—Deletes all ejector pins in the current assembly.
Add Ejector Bores—Checks and adds the cutouts for every assembled ejector pin if these are not present.
In Drawing Mode Only: Add drawing symbols—Places drawing symbols on all ejector pin cutouts in the drawing model. Add notes to the drawing to see the ejector ID.
* 
You can use Trim to quilt/refmodel on all ejector pin types. To define the quilts, click EMX Part Mode > Preparation > Identify trim faces or EMX Assembly > Preparation > Identify trim faces.
If a trim surface is defined then Creo Expert Moldbase Extension uses the Solidify feature to create the trimmed surface.
If no trim surface is defined then Creo Expert Moldbase Extension trims the ejector pin against the solid using the Mold Design Trim to Geometry.
When you use an ejector pin as a core pin, you must assemble a different hole type to the extracts. Select these hole types from a list of fixed rotation hole types.