Highlighting the Path of a Selected Block
You can emphasize the path of the block selected in the diagram using the Highlight Path command. The highlighted path shows the connectors and blocks between the start node, the selected block, and the end node.
To switch between turning the highlighting of the path for a selected block on and off, do the following:
• Click the block and then select > .
When a checkmark appears to the left of the Highlight Path command, the path from the start node to the end node for the block is highlighted. When no checkmark appears to the left of this command, the path for the block is not highlighted. Clicking any other block or clicking in an empty area of the diagram also clears the highlighting.
 | If the cut sets or path sets for a diagram have been calculated, you can highlight them as described in Highlight Cut Sets or Path Sets for a Block Diagram. |