 |
For information about What’s New in the PTC Admin Center, see Release Notes in the Help Center for the PTC Admin Center.
|
|
|
For information about What’s New in the PTC Admin Center, see Release Notes in the Help Center for the PTC Admin Center.
|
|
Open Beta for Vuforia Capture Now Available in Vantage for iOS
The open beta for Vuforia Capture on iOS is now available from within Vuforia Vantage. Contact your Customer Success representative or PTC Technical Support to gain access to the Vuforia Capture for Mobile (iOS only) beta.
For more information, see Vuforia Capture for iOS Mobile (Beta).
|
||
|
iOS
• The wayfinder for occluded part markers now appears more often to point to the occluded parts.
• The wayfinder angle calculation has been improved to more accurately point towards its target.
• Feedback images taken manually are now cropped to contain only what was on the display when the photo was captured. Previously, due to different aspect ratios of the camera and screen, the images sometimes contained more area at the borders than was shown while capturing the image.
• The photo capture and review screens have been updated to simplify the UI by removing the Cancel button and replacing it with a Done button to exit the current screen.
|
||
|
Android
• The wayfinder for occluded part markers now appears more often to point to the occluded parts.
• The wayfinder angle calculation has been improved to more accurately point towards its target.
• Feedback images taken manually are now cropped to contain only what was on the display when the photo was captured. Previously, due to different aspect ratios of the camera and screen, the images sometimes contained more area at the borders than was shown while capturing the image.
• The photo capture and review screens have been updated to simplify the UI by removing the Cancel button and replacing it with a Done button to exit the current screen.
|
||
|
RealWear
Vuforia Vantage is no longer supported on RealWear HMT-1 devices, as RealWear has announced that the HMT-1 devices are at end-of-life and will no longer receive firmware or security updates beyond v12.6. We encourage you to upgrade to RealWear’s Navigator series for continued device support from PTC. For more information, see RealWear’s RealWear HMT-1 and HMT-1Z1 End of Security Update support notice and Firmware Update and Support Policy.
|
|
RealWear
Vuforia Capture is no longer supported on RealWear HMT-1 devices, as RealWear has announced that the HMT-1 devices are at end-of-life and will no longer receive firmware or security updates beyond v12.6. We encourage you to upgrade to RealWear’s Navigator series for continued device support from PTC. For more information, see RealWear’s RealWear HMT-1 and HMT-1Z1 End of Security Update support notice and Firmware Update and Support Policy.
|
|
Pass State Image Displayed in Step Check Section of a Step Card
The Step Check section of a step card now displays an image from the Pass state if one has been captured.
|
|
Settings Bar on Step Check Dashboard Removed
The Settings bar on the Step Check dashboard has been removed; configuring the mode (Setup/Active) for a step can now be done exclusively through the STEP CHECK tab.
|