Enable Auto Provisioning
An administrator can enable auto provisioning for their organization in the PTC Admin Center.
 |
SSO must be configured for your organization to use auto provisioning. If SSO is not configured, PTC Admin Center will indicate that auto provisioning is not available for your organization. Follow the steps described in Configuring Single Sign-On to set up SSO.
|
Perform the following steps to enable auto provisioning:
1. Sign in to the PTC Admin Center.
2. Go to the Auto Provisioning page and observe that auto provisioning is disabled by default.
3. Click Enable Auto Provisioning. The Enable Auto Provisioning page appears. From this page, you can:
1. Select the domains from your organization’s SSO connection that should auto provision users.
2. Select the default organization role that the auto provisioned users should be assigned.
3. Select the default product that the auto provisioned users should be assigned.
|
|
If you select Creo+ as the default product, follow instructions to configure auto assignment in the Creo+ Portal so that licenses are assigned to the auto provisioned users.
|
4. Optionally, select the default groups that the auto provisioned users should be assigned to. If no groups are available, click Create Group to create a new group.
|
|
Groups are not available if Vuforia Expert Capture is the only product assigned to your organization.
|
4. Click Enable to confirm the domains that are affected.
5. The Auto Provisioning page shows that the configuration is enabled with all the selected configurations.
|
|
PTC recommends applying the principle of the least privilege for auto provisioned users to give them the minimum role permissions and product access needed. You can always modify users' roles and product access after they are auto provisioned.
|