About the Strip Wizard
Click PDX Tools > Create Strip to open the Strip Wizard and create a strip. Click PDX Strip > Setup > Edit Strip to update an existing strip. Pan and zoom in the Strip Wizard are identical to pan and zoom in Creo Parametric.
Click an option to define or modify a strip and then type a value for the option:
Strip Assembly—Name for the strip assembly.
Strip Part—Name for the strip part.
Pitch—Value for station width and strip progression.
Height—Value for station height.
Project Prefix—Project prefix.
Number of Stations—Value for the number of stations.
Offset Before—Offset value before the first station.
Offset After—Offset value after the first station.
The following information also appears in the Strip Wizard:
Usage—Use of available material (in percent).
Total Length—Strip length.
Material—Name of the material assigned to an article.
Cost per Station—Cost per station based on material use and cost parameters.
Blank Area—Area of a strip station which is covered by the article.
Scrap Area—Area of a strip station which is not used.
Station Area—Complete area of a strip station.
* 
When working with a complex strip it can be difficult to select a specific element. If more than one element is selected, middle-click and select the element from the shortcut menu.
Was this helpful?