Configuring a review (Reviewer)
Important: Any changes you make to a Review will apply to all Reports that use that Review and all users of the model's Database server.
To configure a review:
1. In the first drop-down-list on the toolbar, select the Report in which you want to include the Review.
2. On the toolbar, click 
Configure Report.
Configure Report.3. On the Config dialog, click the tab that shows the Review you want to change.
4. Select the Review you want to change.
5. If you want the Ignore button to be available for failures of the Review, select the Allow Review Items to be Ignored check box.
6. If you want the Review to apply to additional item types that have been created through Stereotypes:
a. Click the Applies To button.
b. In the Applies To dialog, click the 
button.
button.c. Enter the name of the Stereotype, and then click the OK.
You can specify only Stereotypes that are based on item types that are reviewed by the Review.
7. If you want to change the Review Review's options:
a. Click the Config button.
Note that some Reviews do not have any configuration options.
b. In the dialog, set the options as required.
c. Click OK.
8. From the Priority list, you can select the priority of the highlighted item type. The default values that you can select from the list are:
◦ None (Blank)
◦ Must
◦ Should
◦ Could
◦ Won’t
These values are stored in the Global.ini file that is located here: %ProgramData%\PTC Integrity Modeler\ModelerATFiles\Reviewer. You can modify the priority values to suit your requirements. For example, you can edit the file to change the values to High, Medium, and Low, as shown below:
[Priority]
0=
1=High
2=Medium
3=Low
You can write your own VBScript code to customize the behavior and/or modify the values in the Global.ini file
9. From the Config dialog, click OK.