Detailed Drawings > Setting Up and Configuring Drawings > Setting Drawing Parameters > Material Parameters for Drawings
  
Material Parameters for Drawings
You can set the following material parameters in the report table in a drawing. When you set the material parameters and update the report table, values displayed in the report table are the same as in the drawing.
PTC_YOUNG_MODULUS
PTC_POISSON_RATIO
PTC_MASS_DENSITY
PTC_THERMAL_EXPANSION_COEF
PTC_TENSILE_ULTIMATE_STRESS
PTC_COMPR_ULTIMATE_STRESS
PTC_SHEAR_ULTIMATE_STRESS
PTC_THERMAL_CONDUCTIVITY
PTC_SPECIFIC_HEAT
PTC_HARDNESS
PTC_CONDITION
PTC_INITIAL_BEND_Y_FACTOR
PTC_BEND_TABLE
PTC_MATERIAL_DESCRIPTION
PTC_MATERIAL_NAME
PTC_HARDNESS_TYPE