SHA_ADD_LIP adds a lip, a sheet along the whole length of an edge,
to a sheet metal part.
+----------------<----------------------------+
| |
-->(SHA_ADD_LIP)--+--(:LIP_EDGE)----------|edge|----------------+-->
| |
+--(:LIP_LENGTH)--------|length|--------------+
| |
+--(:LIP_ANGLE)---------|angle|---------------+
| |
+--(:RADIUS)------------|confirmed radius|----+
| |
+--(:BEND_PROCESS)------|process name|--------+
| |
+--(:CHECK_SHEET)----+--(:ON)---+-------------+
| |
+--(:OFF)--+
The following options are available to add a lip to a sheet metal
part.
-
:LIP_EDGE - specifies the edge where to add the lip.
-
:LIP_LENGTH - specifies the overall length of the lip.
-
:LIP_ANGLE - specifies the angle of the lip relative to the
base sheet.
-
:RADIUS - specifies the bend radius.
-
:BEND_PROCESS - specifies the bend process to use.
-
:CHECK_SHEET - specifies whether or not to check the sheet metal part.
Use this action when designing sheet metal parts with PE/Sheet Metal.
SHA_ADD_HEM terminate action
SHA_ADD_SHEET_BY_OUTLINE terminate action
SHA_ADD_SHEET_BY_POLYLINE terminate action
SHA_OFFSET terminate action
![[Contents]](toc.gif)
![[Index]](index.gif)
![[Books]](books.gif)