CoCreate OneSpace Designer - Commands Reference Manual

SHA_OFFSET inserts an offset, a two times 90 degree bend, in an existing sheet metal part.

Syntax

                 +-------------------<----------------------+
                 |                                          |
-->(SHA_OFFSET)--+--(:SIDE_EDGE)--------|edge|--------------+-->
                 |                                          |
                 +--(:POSITION)---------|point 3d|----------+
                 |                                          |
                 +--(:RISING_FACE)------|face|--------------+
                 |                                          |
                 +--(:OFFSET_PROCESS)---|process name|------+
                 |                                          |
                 +--(:OFFSET_HEIGHT)----|confirmed height|--+
                 |                                          |
                 +--(:CHECK_SHEET)------+--(:ON)---+--------+
                                        |          |
                                        +--(:OFF)--+

Options

• :SIDE_EDGE - specifies an edge normal to the offset bends.
• :POSITION - specifies the position of the offset.
• :RISING_FACE - specifies the moving portion of the sheet.
• :OFFSET_PROCESS - specifies the offset bend process to use.
• :OFFSET_HEIGHT - specifies the distance between the two sheet portions.
• :CHECK_SHEET - specifies whether or not to check the sheet metal part.

When to use

Example

See also