CoCreate OneSpace Designer - Commands Reference Manual

Creates a can body part (such as a transistor).

Syntax

    (SDPCB_CAN_MODEL)
        (:PARTNAME)       | part name |
        (:PARTTYP)        | part type |
        (:CAN_CENTER)     | 2D position |
        (:CAN_HEIGHT)     | positive length |
        (:CAN_DIAM)       | positive length |
        (:BASE_DIAM)      | positive length |
        (:BASE_HEIGHT)    | positive length |
        (:NOSE_LENGTH)    | positive length |
        (:NOSE_WIDTH)     | positive length |
        (:NOSE_ANGLE)     | number |
        [ (:MOUNT_CLEAR)  | positive length | ]

Options

• :PARTNAME - specifies a part name.
• :PARTTYP - specifies a part type (e.g. resistor)
• :CAN_CENTER - specifies a 2D position.
• :CAN_HEIGHT - specifies the height of the body.
• :CAN_DIAM - specifies the diameter of the body.
• :BASE_DIAM - specifies the diameter of the base.
• :BASE_HEIGHT - specifies the height of the base.
• :NOSE_LENGTH - specifies the length of the nose.
• :NOSE_WIDTH - specifies the width of the nose.
• :NOSE_ANGLE - specifies the orientation of the nose with an angle in degrees.
• [ :MOUNT_CLEAR - specifies the mounting clearance of the part. ]

See also