CoCreate OneSpace Designer - Commands Reference Manual

CURVE_SETTINGS terminate action

CURVE_SETTINGS enables you to adjust which viewports are to be displayed in multiview mode.

Syntax


                        +-------------------------------<------------------------------------+
                        |                                                                    |
->-(CURVE_SETTINGS)-----+-(:VPY)--------------+-(:ON)---+------------------------------------+->-
                        |                     |         |                                    |
                        |                     +-(:OFF)--+                                    |
                        |                                                                    |
                        +-(:STANDARD_VP)------+-(:ON)---+------------------------------------+
                        |                     |         |                                    |
                        |                     +-(:OFF)--+                                    |
                        |                                                                    |
                        +-(:VPZ)--------------+-(:ON)---+------------------------------------+
                        |                     |         |                                    |
                        |                     +-(:OFF)--+                                    |
                        |                                                                    |
                        +-(:VPX)--------------+-(:ON)---+------------------------------------+
                                              |         |
                                              +-(:OFF)--+

Options

This command has the following options:

:VPY - specifies the uw viewport to be displayed when switching to multiview mode.
:STANDARD_VP - specifies the user viewport to be displayed when switching to multiview mode.
:VPZ - specifies the uv viewport to be displayed when switching to multiview mode.
:VPX - specifies the vw viewport to be displayed when switching to multiview mode.

When to use

Use this command to change the viewports included when using multiview mode.

Example

The following parameter sequence specifies the vw viewport not to be displayed in multiview mode: