CoCreate OneSpace Designer - Commands Reference Manual

CURVE_OFFSET enables you to displace a series of selected edges from a solid or face part and combine them in a specified wire part.

Syntax

                        +-------------------------------<------------------------------------+
                        |                                                                    |
->-(CURVE_OFFSET)-------+-(:WIRE_PART)-------------|select part|-----------------------------+->-
                        |                                                                    |
                        +-(:CURVES)----------------|select edges|----------------------------+
                        |                                                                    |
                        +-(:DISTANCE)--------------|length|----------------------------------+

Options

This command has the following options:

• :WIRE_PART - specifies the name of the wire part to which the gathered 3D curves will belong.
• :CURVES - specifies the edges of the existing geometry to be offset.
• :DISTANCE - specifies the distance through which the 3D curves will be offset.

When to use

See also