Creo NC Sheetmetal > CL Output and Menus > CL Commands > About CL Commands
  
About CL Commands
The SMM CL COMMAND dialog box enables you to include specific post-processor commands for NC output. These commands are output to the NC sequence CL file. If you add a tool motion command, the corresponding motion is shown in the tool path display on the screen.
When entering CL commands, you can enter parameters, preceded by an ampersand sign (&). If there is a corresponding parameter defined in relations, its value is used in the CL command. If the parameter is not found, the system prompts you to enter the type and value of the parameter, and this parameter is added to the relations. This way, the CL command can be changed at the top level (through Relations).