Creo ModelCHECK > checks > PRT_DENSITY (Model Density)
PRT_DENSITY (Model Density)
Y/N/E/W
Reports when the density of a part or the density of a body in the part is not in the range of values defined in the DENSITY_LOW and DENSITY_UPP constant configuration options. If the density is not in the specified range, provides an option to update the density from the ModelCHECK report.
The acceptable limits are set using the DENSITY_LOW and DENSITY_UPP constant configuration options.
Suggested Settings:
Inter
Batch
Regen
Save
W
W
W
E
Part Mode Checks
About Material Parameters
Was this helpful?