Creo ModelCHECK > checks > M3B_TANG_CONT (Tangential Continuity)
M3B_TANG_CONT (Tangential Continuity)
Y/N/E/W
In wire geometry, GeomIntegrityCHECK reports the curve segments or curves whose tangential angles exceed the configuration angle value.
In surfaces, GeomIntegrityCHECK measures and compares tangential angles of two segments along a common border. If the maximum difference among the angles exceeds the configuration angle tolerance, the affected segment boundary is reported.
In topologies, the tangency angle or normal angles of two faces in a common boundary curve are checked at several points. If the angle difference exceeds the configuration angle tolerance, GeomIntegrityCHECK reports the affected boundary curve.
Suggested Settings:
Inter
Batch
Regen
Save
E
E
N
N
Was this helpful?