Creo ModelCHECK > checks > M3A_POSITION_CONT (Position Continuity)
M3A_POSITION_CONT (Position Continuity)
Y/N/E/W
In wire geometry, GeomIntegrityCHECK reports discontinuities in curve and curve-segment transition points that exceed the configuration tolerance.
GeomIntegrityCHECK checks individual bounded surfaces and their segments for continuity in position, gradient, and curvature at several points. It reports discontinuities.
In topologies, GeomIntegrityCHECK checks at several points the parity of two common boundary curves. If the gap between the curves exceeds the configuration tolerance, GeomIntegrityCHECK reports the affected face boundary.
Suggested Settings:
Inter
Batch
Regen
Save
E
E
N
N
Was this helpful?