Creo ModelCHECK > checks > M1_TINY_ELMNT (Tiny Elements)
M1_TINY_ELMNT (Tiny Elements)
Y/N/E/W
In wire geometry, GeomIntegrityCHECK reports the elements in your model that are smaller than specified in your configuration files.
In surfaces, GeomIntegrityCHECK reports the faces and face patches whose length in at least two opposing directions is smaller than specified in your configuration file.
GeomIntegrityCHECK reports bounded surfaces that are smaller than specified in your configuration file.
GeomIntegrityCHECK reports the solids whose expansion in two spatial directions is smaller than specified in your configuration file.
GeomIntegrityCHECK reports the drawing elements that are smaller than specified in your configuration file.
Suggested Settings:
Inter
Batch
Regen
Save
E
E
N
N
Was this helpful?