Creo ModelCHECK > Using GeomIntegrityCHECK > Setting Check Criteria
Setting Check Criteria
* 
If you set the MC_VDA_RUN configuration option in the config_init.mc file to run GeomIntegrityCHECK along with Creo ModelCHECK , the check criteria and values are read from the Creo ModelCHECK check configuration and constant configuration files.
Before you set the criteria for a particular check, click Load in the ModelCHECK Configuration Tool for GeomIntegrityCHECK settings to select a configuration directory and a configuration file. The names of the selected configuration directory and configuration file are displayed in the Config Directory and Config File boxes, respectively.
When you select the desired file, all of the required criteria and their values are shown. By default, they are read from the config.gmc file in the directory specified by the $MCDIR environment variable.
* 
The configuration file must have the .gmc extension.
The tabbed pages under Geom Checks and Allowed Values contain the criteria used to check models. These are default values that Creo ModelCHECK retrieves from the configuration file. The values are listed in millimeters. Creo ModelCHECK converts them automatically if they are entered in a different unit of measure.
After you make your choice of settings, you can save the settings to the same configuration file or a new configuration file. If you save them to a new configuration file, you can reload the file later by clicking Load. When you save a file, the .gmc extension is appended.
Was this helpful?