Natural Convection Exercise 7—Performing the Simulation
* 
Monitoring points must be created before you perform the simulation.
1. In the Flow Analysis Tree, under Physics select Common.
2. In the Properties panel, Model tab, set values for the options as listed below:
Number of Iterations—1000
Time DefinitionSteady State Simulation
Result Saving Frequency—1000
3. In the Run group, click Run to begin the simulation. The default settings are set to Start from Initial Values and Steady in the Run group.
4. If the Info dialog box opens, click Yes to generate the mesh and continue.
5. Click XYPlot Panel to view the residuals for the steady simulation.
6. Click OK when the simulation is complete.
* 
The convergence criteria used for this simulation is 1e-6. The simulation is completed when the residuals for all the variables drop by 6 orders or the maximum Number of Iterations is reached.
これは役に立ちましたか?