Cabin Radiation with Convection and Radiation: Exercise 2—Defining Physics Modules
Physics specifications are handled in Creo Flow Analysis using modules.
1. In the Flow Analysis Tree, right-click
Physics and select
Select Physical Models or click
Physics Module. The
Physical Model Selection dialog box opens.
2. Under
Available Modules, select
Turbulence and click
.
3. Under
Available Modules, select
Radiation and click
4. Under
Available Modules, select
Particle and click
.
5. Click Close to close the Physical Model Selection dialog box.
Specifying Flow Module Conditions
1. In the Flow Analysis Tree, under Physics select Flow.
2. In the Model tab, set the following values for the options listed:
◦ Converge Criterion — 1e-06
◦ Gravity force — Yes
▪ Z— -9.8 m/s2
Specifying Radiation Module Conditions
1. In the Flow Analysis Tree, under Physics select Radiation.
2. In the Model tab, set the following values for the options listed:
◦ Converge Criterion — 1e-06
◦ Source — add Parallel Source
▪ Direction — -1, -0.3, -0.5
▪ Power Density — 500 W/m2