5. Click the
References tab, click
under
Draft Line Selection, and select the reference curve. The reference curve must lie outside the reference part geometry.
6. The system automatically determines the surfaces that the draft is tangent to. However, if you are not satisfied with the automatic selection, click
under
Tangent To and select the appropriate surfaces on the reference part.
7. Click
to preview the tangent draft geometry. If required, you can change the draft geometry by specifying the
Closing Surfaces,
Spine Curves, or
Cap Angle, located on the
Options tab. You can also edit the reference curve by using the
Curves tab.
8. When satisfied with the feature geometry, click
to close the dialog box and create the feature.