To Transform Parting Surfaces
1. Perform one of the following steps:
◦ On the
Mold tab, click
Parting Surface. The
Parting Surface tab opens.
◦ On the Cast tab, click Transform Tools in the Parting Surface Design group.
2. Create a parting surface. Alternatively, you can redefine an existing parting surface.
3. Perform any of the following steps to transform the volume:
◦ Use the
Move or
Offset command to move or offset a surface, respectively.
◦ Use the
Modify Analytic command to modify the base dimensions that drive the analytic surface.
◦ Use the
Substitute command to substitute or replace a quilt with another quilt.
◦ Use the
Edit Round or
Edit Chamfer command to modify the rounds or chamfers, respectively.
4. Click
OK.