About the Creo ModelCHECK Operating Modes
Each check has the following options:
• Y-Runs the check
• N-Does not run the check
• E-Displays an error message if the check fails
• W-Displays a warning if the check fails
You can run Creo ModelCHECK in four modes, depending on how it is configured.
• Interactive mode—Runs Creo ModelCHECK when you click File > Prepare > ModelCHECK Interactive in Creo Parametric.
• Regenerate mode—Runs Creo ModelCHECK after every regeneration. Running Creo ModelCHECK in Regenerate mode is the most effective use of Creo ModelCHECK. In this mode, Creo ModelCHECK automatically runs every time you regenerate the model. Problems are found immediately after they occur when they are easier to correct.
• Save mode—Runs Creo ModelCHECK after every save operation.
• Batch mode—Runs Creo ModelCHECK outside of Creo Parametric. Use Batch mode to run Creo ModelCHECK on a number of parts, assemblies, or drawings.
You can customize each mode to run a different set of checks.