Flow through a Nozzle: Project 1

Creo Tutorials > Creo Flow Analysis Tutorials > Advanced Tutorials > Creo Flow Analysis Advanced Tutorials > Tutorial 7 - Flow through a Nozzle > Flow through a Nozzle: Project 1—Base Model

Flow through a Nozzle: Project 1—Base Model

In this project, the base geometry (Rep0001) with the base flow rate is simulated. This base model will be used for the Flow through a Nozzle: Project 2—Parametric Analysis. It is recommended that the user does not to skip this simulation.

The exercises in the Flow Analysis simulation are:

• Base Model Simulation Exercise 1—Extracting the Fluid Domain

• Base Model Simulation Exercise 2—Preparing the Mesh

• Base Model Simulation Exercise 3—Defining Physics Modules

• Base Model Simulation Exercise 4—Assigning Boundary Conditions

• Base Model Simulation Exercise 5—Performing the Simulation

• Base Model Simulation Exercise 6—Analyzing Results

Was this helpful?