Route cables manually from pin to pin
You can directly route cabling between the pins of connectors and terminals.
To manually route cabling between pins,
1. Click
Cabling and then, in the
Manual Routing group, click
Pin to Pin. The
Create Cable dialog box opens.
◦ If a cable is selected, click Connector in the Start Point section.
◦ If a wire is selected, click Point or Pin/Termnl in the Start Point section.
| • For Point, you can directly select the center of the conductor. • For Pin/Termnl, you can select the connector from the list. |
4. Select the connector in the viewport.
5. Assign pin numbers to the conductors.
◦ Click Set All to automatically map pins to conductors.
◦ Click Clear All to clear the current mappings.
6. Click Accept.
7. Use the copilot to adjust the position of the conductors with respect to the connector:
8. Use Tang Dir and TangLen to adjust the cable's tangency.
9. In the End Point section, repeat steps 4 through 9 for the other connector.
10. Click
Next to manually route other cables from pin to pin, or click
to complete the operation.
