CoCreate OneSpace Designer - Commands Reference Manual

AM_CREATE_DIM_DIAMETER creates diametric dimensioning.

Syntax

                              +------------<-------------<------------<------------+
                              |                                                    |
                              |                                                    |
--->(AM_CREATE_DIM_DIAMETER)--+---+---|1st ref pnt|---|2nd ref pnt|---|position|---+---->
                              v   ^
                              |   |
                         +<---+-<-+---<+
                         |             |
                         +-----{2}---->+
                         |             |
                         +-----{3}---->+
                         |             |
                         +-----{4}---->+
                         |             |
                         +-----{5}---->+
                         |             +-------<------+
                         |                            |
                         +--(:CENTERLINE)--+--(:ON)---+
                                           |          |
                                           +--(:OFF)--+

Options

• :CENTERLINE determines whether a line through the center of the circle or arc is drawn (:ON) or not (:OFF).

This command also takes the following general dimensioning options:

{2}	"Fix" options
{3}	"Fix" Table options
{4}	Tolerance options
{5}	Tolerance Table options

See Dimensioning Options for logics and descriptions of these options.

When to use

See also