One Round Piece with Three Patches
|
Two Round Pieces without Patches
|
---|---|
After you select the edge reference, the system automatically propagates the round piece across all tangent points resulting in tangent segments called patches. In the illustration below, tangency occurs due to the existing round geometry.
|
After you select two edge references, they system places two separate round pieces at the selected references to create the round. In the illustration below, tangency does not occur due to the vertex. This results in the two overlapping round pieces. The system uses transitions to resolve this discontinuous geometry.
|
1. Edge reference 2. Patch 3. Patch 4. Patch 5. Existing round geometry |
1. Edge references 2. Discontinuous round geometry |