Creo Options Modeler > Creo Options Modeler > Using PTC Creo Options Modeler > References and Dependencies > Reference Views > About Breaking Dependencies
  
About Breaking Dependencies
When you work with Product Development Management (PDM) systems, you must check out and check in your models. While you work on a checked out model, references may be created to objects that are not in the work space. These objects are referred to as ghost objects. Dependencies created to ghost objects are dummy dependencies. Before you save the model or check it in to the PDM system, you must break these dummy dependencies. If removing a dependency would cause the assembly to fail regeneration, the feature is frozen.
Use the Reference Viewer to investigate and break object dependencies. You can break dependencies identified by the icon. When you break a dependency, the object is removed from the Reference Viewer graph.
The following dependency types can be broken:
Dependency
Type of Break
Data Sharing Features (DSF)
Regenerates the DSF in the component.
Notebooks
Removes the dependency and makes the object fully independent of its declared notebook.
Interchange assemblies
Removes the dependency and makes the object independent of the interchange assembly.
Mirrored models
Removes the dependency when the mirrored model is created as not geometry dependent. You cannot break the dependency when the mirrored model is created as geometry dependent.
Old assembly cuts
Removes the dependency.
Replaced components
Removes the dependency.
Unused substitute components
Removes the dependency.
 
* Restructuring components in assemblies from releases including and before Wildfire 4 created dependencies. These dependencies are visible in the Reference Viewer and can be removed.