In this example you will pull a profile to part p1 from the active workplane (w1) without keeping the workplane or profile for the next operation. The figure below shows the target part (1), the workplane containing the profile to be pulled (w1), and the pulled part (2).
After creating the workplane and profile:
1. Click Modeling and then, in the Model group, click the arrow next to Pull.
2. Click Pull Linear. The Pull dialog box opens. Part is set to the active part p1 and Workplane is set to the active workplane containing the profile w1. You do not need to change the workplane but you need to create a new part p2.
3. In the Part box, type /P2.
4. In the Type box, select To Part and select the target part p1. Creo Elements/Direct Modeling displays p1 in the To Part box.
Creo Elements/Direct Modeling shows a preview of the pulled part p2 in the viewport.
5. Clear Keep WP. Keep Prof is automatically disabled.
6. Click to complete the operation. Creo Elements/Direct Modeling pulls the profile and creates the new part.
Pull.
to complete the operation. Creo Elements/Direct Modeling pulls the profile and creates the new part.