About the Workflow in Creo Expert Moldbase Extension
Starting from an existing cavity insert Assembly the basic Creo Expert Moldbase Extension workflow contains the following steps:
1. Prepare the cavity insert assembly in Creo Parametric manufacturing:
a. To define the functions of the cavity insert assembly components., click > . The Classify dialog box opens.
b. If multiple cavity copies are required for a mold base project click > . The Create Insert Copies dialog box opens from which you can create dependent copies of the assembly.
c. If ejector pins and lifters need to be trimmed against quilt surfaces, identify trim faces within the reference model by clicking > .
| If no cut quilt is selected as a trim surface, ejector pins are trimmed against the solid of the reference model. Lifters cannot be trimmed. |
2. Create the new project:
a. Click > . The Project dialog box opens.
b. Add project information as required and click OK to close the dialog box and create the new project.
3. Set up the assembly structure:
Click > . The Subassembly dialog box opens.
4. Define the layout of the cavity insert assembly pattern and assemble the cavity insert assemblies:
Click > . The Cavity dialog box opens.
5. Create plates, guide components, and major equipment:
Click > to open the Mold Base Definition dialog box. Set various options in this dialog box and then click OK after creating the required components.
6. Load an existing mold base assembly, add, modify or delete plates, locate rings, sprue bushings, guide components, and standard screws:
In the
Mold Base Definition dialog box. click
. You can also define machine data. Click
OK after defining the required components.
7. Define the layout of the cavity insert assembly pattern and to assemble the cavity insert assemblies.
Click > . The Cavity dialog box opens.
8. See the status of the component:
Click > to open the Component Status dialog box.
9. Add screws, ejector pins, cooling system, sliders, and so on:
Click
EMX Components and then in the
Components group, select a component . Click
Preview to check component properties before assembly.
10. Use an editable library component:
Click > . The Library Component dialog box opens.
11. Analyze the model and finish the design:
Click EMX Assembly and then in the EMX Tools group, select a tool to use for the analysis.
12. Generate a Bill of Materials.
Click > . The Bill of Materials dialog box opens.
Customizing Creo Expert Moldbase Extension
You can customize Creo Expert Moldbase Extension with Administrator Tools.
• To customize the EMX display click > and apply configuration options from the EMX Options dialog box.
• To make your specific changes to the component or mold base database, click > and then click Component Editor or click Mold Base Editor.