Saving the Position of Resources and Operated-on Parts
You can drag the resources and operated-on parts allocated to an operation to a different position and then save the new position using the 
Update Position action. This action is enabled only if a single resource or operated-on part is selected and the Process Plan Browser is in the Playback mode. For information on the Playback mode, see Viewing a Process Plan Playback.
Update Position action. This action is enabled only if a single resource or operated-on part is selected and the Process Plan Browser is in the Playback mode. For information on the Playback mode, see Viewing a Process Plan Playback.Perform the following steps:
1. Select a resource or operated-on part in the Process Plan Browser.
2. In the Visualization sub-tab, click Update Position.
Update Position. | The new position is saved if the Save Position of Resources, EPM Documents and Operated-on Parts During Process Plan Playback Without Launching the Update Position Dialog Box preference is set to Yes. If it is set to No, the Update Position dialog box appears for you to further edit the position. |
3. In the Update Position dialog box, edit the xyz coordinates for point and angle of resources and operated-on parts as required.
4. Click OK.
The new position of resources or operated-on parts is saved.