Adding Authoring Application Parameters
Default system parameters are pushed from Windchill when a CAD part or drawing is saved or checked in, and they appear on the page discussed below. You can keep these parameters, change them, or create new ones. Use the following process to access the page to add a new parameter.
To add new parameters, select Custom on the Drawing Properties page.
 |
Hyperlinks are not supported; therefore Hyperlink base is not valid for mapping.
|
The following is a list of standard parameter names that can be mapped either to a custom parameter name or a standard Windchill system attribute (using the server-side preferences mapping functionality) to put the values of the Windchill system attribute into a parameter. The labels that should be used are listed in the next table.
|
Parameter Name
|
Description
|
|---|---|
|
MSP:AUTHOR
|
Publishes Author on Summary tab.
|
|
MSP:COMMENTS
|
Publishes Comment on Summary tab.
|
|
MSP:KEYWORDS
|
Publishes Keywords on Summary tab.
|
|
MSP:SUBJECT
|
Publishes Subject on Summary tab.
|
|
Naming Parameter=MSP:TITLE
|
Publishes Title on Summary tab.
|
|
|
1. The MSP:* comments that are present in the CAD Documents will not be sent to Windchill if they are not mapped in Windchill. When MSP:* are mapped to Windchill, they behave as mapped IBA's. There will not be any visible changes to User Interface(UI) behavior with this implementation.
2. When Naming Parameter=MSP:TITLE is mapped in > > > , the CAD document name is published in the Title field on the > > tab in AutoCAD.
|