Configure the Lifecyclemap.properties File
The lifecycle.map.properties command assigns a lifecycle to a WTPart. All states of the lifecycle link to the WTPart. It is necessary to specify the mapping properties of the WTPart.
The lifecyclemap.properties command can be found in the following directory:
<Windchill>\codebase\com\ptc\windchill\pdmlink\proimigration
 |
• If lifecycle mapping is not found in the file, the lifecycle and state for a newly created part becomes created by the object initialization rule for the part.
• If lifecycle mapping does not exist in the file, and if the CAD-document has lifecycle mapping, an exception may occur when the lifecyclemap.properties is NOT mapped properly.
|
This table lists the rules and definitions of the lifecyclemap.properties command.
|
Rule (Shown with Default Value)
|
Definition and Usage
|
|---|---|
|
LifeCycleTemplate=Life CycleTemplate
|
This rule specifies that the left side of the lifecycle is equal to the right side of the lifecycle. For example,
Basic=Review
|
|
LifeCycleTemplate. StateifeCycleTemplate .State
|
This rule specifies that the left side of the lifecycle state is equal to the right side of the lifecycle state. The left side of lifecycle can be different from the right side of lifecycle. For example,
Basic.INWORK=Review. UNDERREVIEW
|