Integration with Other Applications > Windchill Workgroup Manager Documentation > Autodesk Inventor
  
Autodesk Inventor
Finding Information About Windchill Workgroup Manager for ../common/conref_product.dita#ptcProduct/AutodeskInventor
To make it easier to locate information that is specific to your application, When documentation is divided between information that is common to all integrations, and information that is specific to each application. This topic describes how documentation is organized.
Common Information for New Users of
If you are new to , you can start with the Introduction to Windchill Workgroup Manager topic that describes the system architecture and the basic concepts. This introduction is common to all applications that are integrated using .
In addition, to learn more about general techniques for managing CAD data and your application data in , see Managing CAD Data.
Installation Documentation
For instructions on how to install and configure , see the on www.ptc.com. You can search for this guide from the Reference Documents page on https://www.ptc.com/en/support/refdoc.
What’s New for This Release
For information on what is new for this release in , see Windchill Workgroup Manager section in the .
Information Specific to ../common/conref_product.dita#ptcProduct/AutodeskInventor
Information specific to ../common/conref_product.dita#ptcProduct/AutodeskInventor is covered in the following sections:
Subject
Description
Intended Audience
Describes PDM actions specific to ../common/conref_product.dita#ptcProduct/AutodeskInventor
User
Discusses advanced practices of .
Experienced user, power user
Describes how to configure ../common/conref_product.dita#ptcProduct/AutodeskInventor with , and other aspects of system management.
Administrator
Lists preferences specific to ../common/conref_product.dita#ptcProduct/AutodeskInventor
For general preferences and how to set them, see Managing Workgroup Manager Preferences.
All