Adding SolidWorks Parameters (SOLIDWORKS)
Default system parameters are pushed from Windchill when a CAD part or drawing is saved or checked in; they are listed below. You can keep these parameters, change them, or create new ones. Use the following process to access the page to add a new parameter.
To add new parameters, select Custom on the Properties page.
* 
Hyperlinks are not supported; therefore Hyperlink base is not valid for mapping.
The following is a list of standard parameter names that can be mapped either to a custom parameter name or a standard Windchill system attribute (using the server-side preferences mapping functionality) to put the values of the Windchill system attribute into a parameter. The labels that should be used are listed in the next table.
Mapping SolidWorks Summary Information to Windchill Attributes
Parameter Name
Description
MSP:AUTHOR
Publishes Author on Summary tab.
MSP:COMMENT
Publishes Comment on Summary tab.
MSP:KEYWORDS
Publishes Keywords on Summary tab.
MSP:SUBJECT
Publishes Subject on Summary tab.
MSP:TITLE
Publishes Title on Summary tab.
* 
1. The MSP:* comments that are present in the CAD Documents will not be sent to Windchill if they are not mapped in Windchill. When MSP:* are mapped to Windchill, they behave as mapped IBA's. There will not be any visible changes to User Interface(UI) behavior with this implementation.
2. When Naming Parameter=MSP:TITLE is mapped in Windchill > Site > Utilities > Preference Management, the CAD document name is published in the Title field on the File > Summary tab in SOLIDWORKS.
Was this helpful?