Adding Authoring Application Parameters (Autodesk Inventor)
Default system parameters are pushed from Windchill when a CAD part or drawing is saved or checked in; they are listed below. You can keep these parameters, change them, or create new ones. Use the following process to access the page to add a new parameter. To add new parameters, select Custom on the iProperties page.
* 
Hyperlinks are not supported; therefore Hyperlink base is not valid for mapping.
The following is a list of standard parameter names that can be mapped either to a custom parameter name or a standard Windchill system attribute (using the server-side preferences mapping functionality) to put the values of the Windchill system attribute into a parameter. The labels that should be used are listed in the next table.
Autodesk Inventor Project Tab Default Parameters
Project Tab Parameter
Published Result
MSP:AUTHORITY
Authority
MSP:COSTCENTER
Cost Center
MSP:DATECHECKED
Date Checked **
MSP:DESCRIPTION
Description
MSP:DESIGNER
Designer
MSP:ENGINEER
Engineer
MSP:MATERIAL
Material
MSP:REVISIONNUMBER
Revision Number
MSP:PARTNUMBER
Part Number
MSP:PROJECT
Project
MSP:VENDOR
Vendor
Autodesk Inventor Status Tab Default Parameters
Status Tab Parameter
Published Result
MSP:CHECKEDBY
Checked By
MSP:DESIGNSTATE
Design State
MSP:ENGAPPROVEDBY
Eng. Approved By*
MSP:ENGDATEAPPROVED
Engr Date Approved **
MSP:MFGAPPROVEDBY
Mfg Approved By
MSP:MFGAPPROVEDDATE
Mfg Approved Date
Autodesk Inventor Summary Tab Default Parameters
Summary Tab Parameter
Published Result
MSP:AUTHOR
Author
MSP:CATEGORY
Category
MSP:COMMENTS
Comments
MSP:COMPANY
Company
MSP:KEYWORDS
Keywords
MSP:MANAGER
Manager
MSP:SUBJECT
Subject
Naming Parameter=MSP:TITLE
Title
* 
1. The MSP:* comments that are present in the CAD Documents will not be sent to Windchill if they are not mapped in Windchill. When MSP:* are mapped to Windchill, they behave as mapped IBA's. There will not be any visible changes to User Interface(UI) behavior with this implementation.
2. When Naming Parameter=MSP:TITLE is mapped in Windchill > Site > Utilities > Preference Management, the CAD document name is published in the Title field on the File > iProperties > Summary tab in Autodesk Inventor.
¿Fue esto útil?