Data Management Capabilities > Managing Configurable Products > Developing Advanced Selection Logic for Configurable Modules > Basic Steps for Defining Advanced Selection > Adding a Constraint > Case Table Editor > Editing a Case Table Parameter
  
Editing a Case Table Parameter
In the Edit Case Table Parameter window, you can set the permissible values for a parameter for the selected parameter types:
* 
The Edit Case Table Parameter icon is available in the Case Table Editor only when the Enable Advanced Case Tables preference is enabled.
1. In the Edit Case Table Parameter window, select how the value is set and the appropriate values. The combination of possibilities depends on the parameter type:
Selected Values: Permissible values are identified with the selection or specification of one or more values. A selection list is provided for parameters defined with a list constraint. A list of entries can be made for suitable parameters without a list constraint.
Not Selected Values: Values that are not permissible are identified with the selection or specification of one or more values. A selection list is provided for parameters defined with a list constraint. A list of entries can be made for suitable parameters without a list constraint.
Specify Range: Specifies the permissible range of values for Integer or Real Number parameter types. For more information, see Specifying a Parameter Range.
All: All values are permissible.
N/A: No value is permitted for this parameter. Applicable only for parameters that are not mandatory.
ELSE: Any value, not permitted elsewhere in the case table for this parameter, is permitted.
2. Click OK.