Issue Description
|
Tracking Number
|
---|---|
When upgrading using ThingworxApps installer, the parameter “Maximum Number of Connection“ on the database things was configured to 5. This was an issue if the system had a lot of activity and waiting time for open connections increased. This is now resolved. When installing a new environment, this parameter will now be configured to 50 connections instead of 5.
|
TAC-6446
|
Fixed an issue where snackbar Widget user (messages shown at bottom right of the display) stopped working.
|
WIDG-269
|
Issue Description
|
Tracking Number
|
---|---|
Fixed an issue where a Job Order could not be executed for specific serial numbers.
|
CWC-5592
|
Fixed an issue where during the execution of a smart tool step, restarting the sequence would update all values to NULL every second under certain circumstances.
|
CWC-5593
|
Fixed an issue in CWC where error messages would not always be shown on different screens (Ex. Scheduling & Route Manager).
|
CWC-5599
|
Fixed an issue where the value captured by a smart tool would not be saved in edge case scenario.
|
CWC-5482
|
Fixed an issue where attributes were not shown on the execution display (ex: manual entry) screen under certain conditions.
|
CWC-5606
|
Fixed an issue where opening the "See All" Popup during execution was showing a blank screen if user loads serial numbers in different parallel positions than their original position, assuming they were already executed, paused and resumed.
|
CWC-5607
|
Fixed an issue where execution display was accepting High Reject but not Low Reject due to rounding. (UI only, database value was correct).
|
CWC-5609
|
Fixed an issue where it was possible to create more than one draft version of a Work Instruction.
|
CWC-5414
|
Fixed an intermittent issue where production may be reported twice by the endpoint when the user completes a work order with many serial numbers and specific timing on the UI interaction.
|
CWC-5023
|
Fixed an issue where User Management screen was only shows up to 500 users.
|
CWC-5543
|
Fixed an issue where returning to execution of parallel serial numbers that were previously started and stopped was failing.
|
CWC-5604
|
Fixed an intermittent issue where the version comment could not be saved when editing a step of a work instruction.
|
CWC-5021
|
Fixed an issue where Work Instructions would display a "Critical Error" in Approval Preview display when bad brackets (placeholders) are found in the HTML Editor.
|
CWC-5413
|
Fixed an issue where conditional execution (Work Order Change) was not working for consecutive steps of different work instructions at the same station.
|
CWC-5605
|