To Unbend an Article
Use > 
Automatic Unbend to automatically unbend an article. You must first select the driving surface to set an anchor for the start of the unbending process. This surface should be on the lower side of the article which will be aligned to the lower side of the strip in a strip design.
Automatic Unbend to automatically unbend an article. You must first select the driving surface to set an anchor for the start of the unbending process. This surface should be on the lower side of the article which will be aligned to the lower side of the strip in a strip design. | This command is intended to create simple Unbend features. Use > for more complicated bends. |