About Exporting Measurement Points
1. Click > > to place measuring points on Creo Parametric solid parts. The Measuring Points dialog box opens.
2. Click 
to select the Reference CSYS in the 3D model.
to select the Reference CSYS in the 3D model.3. The Measuring point list table shows existing measuring points. Each line is represented by one point. Select the symbol in the ID column to create a 3D note. The X, Y, and Z columns show the measuring-point position on the solid part. The (X), (Y), and (Z) columns show the offset position of 0.5 * probe diameter normal to the solid face.
4. Enter the Probe Diameter. This represents the OMM machine ball diameter and will be used to calculate the offset between the original points on the solid and the required measurement position.
5. Enter the Grid Width. This value is used to calculate a grid of x and y positions when a new set of points is created on a solid part with 
.
.6. Click 
to remove the selected entry from the point list.
to remove the selected entry from the point list.7. Click 
to select a position on the model. The position and the related offset point are added as new line to the point list.
to select a position on the model. The position and the related offset point are added as new line to the point list.8. Click 
to save the point list to the file QMM_FILENAME.
to save the point list to the file QMM_FILENAME.9. Click OK to create or update a point in the assembly that represents the position of all measurement points.
10. Click Cancel to close the dialog box without saving.